Chapter 1: Getting Started

• General FINMON Programming
• Trigger Inputs Z1-4 on Transmitter

General FINMON Programming

This page covers the essential programming requirements for all Finmon radio installations.

---

Required Programming Steps

The following must be programmed for the Finmon radio to work via the dialler correctly:

1. Account Code

   • Four digit code as required by control room
   • Must be inserted in all required locations (some panels need it in multiple places)
   • For six digit fields: program the four digits followed by FF (e.g., 1234FF)

2. Telephone Number

   • Program '5555555' in both primary and secondary locations
   • Must be exactly seven 5's

3. Communication Format

   • Contact ID must be enabled
   • This is the standard format for all installations

4. Dial Attempts

   • Minimum of 6 attempts required

5. Dial Timeout

   • For kiss-on (if applicable): minimum 60 seconds
   • If no timeout available, ensure attempts cover:
     • 90 seconds for server send
     • Additional 90 seconds for direct send
     • SMS send time (if enabled)
   • Note: SMS limit is 20 free messages per unit per month

6. Dialing Method

   • Tone dialling must be enabled (usually default)
   • Do not use pulse dialling

7. Special Requirements

   • Forced dialling must be enabled (mostly for Caddx panels)

---

Important Notes

• Always verify all settings before leaving site
• Test communication after programming
• Document any deviations from standard programming

Trigger Inputs Z1-4 on Transmitter

This page covers the configuration of direct trigger inputs on the Finmon transmitter.

---

Default Configuration

Factory Default Account Code: 9998

When a transmitter is connected to a panel via serial/dialler:

• The panel will automatically update the radio with its account code on first signal
• If the account code is changed on the panel, it will update the radio again

---

Direct Connection to Z1-4

When connecting directly to trigger inputs (not through a panel):

1. Account Code Programming

   • Must be set by dialling into the radio over the internet
   • Use Finmon website: www.finmon.co.za
   • REFER TO YOUR FINMON CONSULTANT OR CONTROL ROOM

2. Voltage Requirements

   • The radio requires a positive 12v trip on any of the triggers.
   • Ensure clean, stable 12v signal

---

Default Trigger Assignments

Input	Default Function
Z1	Panic
Z2	Burglary
Z3	Open by user / Close by User
Z4	AC Failure

---

Reprogramming Triggers

The trigger inputs can be reprogrammed for any Contact ID reporting code:

• Examples: supervisor on site, pump failure, temperature alarm
• Access required via Finmon website
• Contact Finmon support for custom programming

---

Wiring Notes

• Use appropriate gauge wire for 12v signals
• Keep wiring runs as short as practical
• Avoid running trigger wires parallel to AC power
• Use shielded cable in high-interference environments