Chapter 6: Texecom Panels
Texecom 412/816/832 Programming
Standard Texecom panels with red serial cable
Version Information
Texecom 412/816:
- Known working app versions: V16.13
Texecom 832:
- Known working versions: v13, v14 (E)
Note: Texecom Elite panels are NOT supported on app, but work with serial for CID
Basic Programming
Access Programming:
- Installer code + Menu + 9
- Default installer code: 1234
Location 70
- Switch ON LEDs 1, 2, 5, and 8
- Press ARM button to confirm
Location 71 Programming:
- 71/0 = 5555555 (tel number) - Press ARM button
- 71/1 = [4-digit account number] - Press ARM button
- 71/2 = 4 (Contact ID) - No need to press ARM
- 71/3 = 6 (dial attempts) - No need to press ARM
- 71/5 = Switch ON all LEDs - Press ARM button
- 71/8 = LED 8 OFF for Tip & Ring / ON for Serial
Location 76
- 76/8 = LED 8 ON (Dialler)
Serial Connection Configuration
For serial connection ONLY:
- 71/8 = LED 8 ON
Texecom 412 Serial Specific
Known working app version: V14
Location 70
- Switch ON LEDs 1, 2, and 8 only
- Press ARM button
Additional for Serial:
- 71/8 = Switch ON 8
- 76/5 = 3 (com IP on Comm 1)
OR (NOT BOTH)
- 76/9 = 3 (com IP on Comm 2)
Converting from Serial to Tip & Ring
If panel was previously on serial and now using Tip & Ring:
- 71/8 = 0
- 76/5 = 0
Special Notes
Texecom 816:
- Serial cable connection must be a Texecom GSM type
Texecom MiAlarm PANEL MODE
Configuration for MiAlarm compatibility
Note: Texecom Elite panels are NOT supported on app, but work with serial for CID
Programming Steps
-
Enter Programming Mode
- Enter Installer Code
- Press Menu button
- Press 9
-
Location 76/0
- Press location 76
- Press sublocation 0
- Ensure LED 1 is ON
- If not ON: Press 1, then YES/Tick button
-
Location 76/2
- Press location 76
- Press sublocation 2
- Enter UDL code: 1234
- Press YES/Tick button
-
Location 76/5
- Press location 76
- Press sublocation 5
- Press 3
-
Exit Programming
- Press Menu button
- Press 99
Important Notes
- This configuration enables MiAlarm compatibility