Chapter 7: Other Panels
Orisec Configuration
Orisec panels support both Tip/Ring and Com Port connections
Orisec Tip/Ring Configuration
- Enter Installer Code
- Select Programming Menu → Tick/Enter
- Go to ARC Set up
- Phone Number: 555 5555
- Account Number: As supplied by control room/software
- Protocol: Contact ID
- Dial Seq: 1
- Any issues with not sending - RESTART PANEL
Orisec Com Port Configuration
- Enter Installer Code
- Select Programming Menu → Tick/Enter
- Com Port Setup → Tick/Enter
- Select Com Port number 2
- Set mode to FINMON (Required for app)
- Hold Tick to go back
- Go to ARC Set up
- Phone Number: F555 5555 (Note the 'F' prefix)
- Account Number: As supplied by control room/software
- Protocol: Contact ID
- Dial Seq: 6
- Any issues with not sending - RESTART PANEL
App Configuration
Requirements:
- App version must be v4.37
- Serial Port must be set to Orisec/IDS
- MUST be set to FINMON under Comm Port Setup
Critical Notes
IF YOU AREN'T GETTING SIGNALS OUT:
- REBOOT THE PANEL
- If serial port connected with panel powered up, it won't be detected
- Always power cycle after connecting serial
Risco Configuration
Complete programming guide for Risco panels
Accessing Programming
Monitoring Station Setup
Configure the following:
- TYPE = VOICE
- CHANNEL = PSTN/GSM
- ACCOUNT = 6 digit code provided by office (e.g., 001052)
- PHONE = 555 555 5
- MS RETRIES = 3
Timer Configuration
- CANCEL DELAY = 0
- ABORT ALARM = 0
Periodic Test Setup
- TIME = 2200 (for 10:00 PM test)
- RECURRENCE = EVERY 1 DAY
Report Split Configuration
- ARM/DISARM = "NON" for DOMESTIC / "CALL MS1 ONLY" for COMMERCIAL
- MS URGENT = "CALL MS1 ONLY"
- MS NON URGENT = "CALL MS1 ONLY"
Cloud Settings
Back to main COMMUNICATION menu
Navigate to "CLOUD":
- MS CALL ALL = ENABLED
- FM CALL ALL = ENABLED