# Chapter 7: Other Panels

# Orisec Configuration

Orisec panels support both Tip/Ring and Com Port connections

---

#### Orisec Tip/Ring Configuration

1. Enter **Installer Code**
2. Select **Programming Menu** → Tick/Enter
3. Go to **ARC Set up**
4. **Phone Number**: 555 5555
5. **Account Number**: As supplied by control room/software
6. **Protocol**: Contact ID
7. **Dial Seq**: 1
8. Any issues with not sending - **RESTART PANEL**

---

#### Orisec Com Port Configuration

1. Enter **Installer Code**
2. Select **Programming Menu** → Tick/Enter
3. **Com Port Setup** → Tick/Enter
4. Select **Com Port number 2**
5. Set mode to **FINMON** (Required for app)
6. **Hold Tick** to go back
7. Go to **ARC Set up**
8. **Phone Number**: F555 5555 (Note the 'F' prefix)
9. **Account Number**: As supplied by control room/software
10. **Protocol**: Contact ID
11. **Dial Seq**: 6
12. Any issues with not sending - **RESTART PANEL**

---

#### App Configuration

**Requirements:**
- App version must be **v4.37**
- Serial Port must be set to **Orisec/IDS**
- **MUST** be set to FINMON under Comm Port Setup

---

#### Critical Notes

**IF YOU AREN'T GETTING SIGNALS OUT:**
- **REBOOT THE PANEL**
- If serial port connected with panel powered up, it won't be detected
- Always power cycle after connecting serial

---

# Risco Configuration

Complete programming guide for Risco panels

---

#### Accessing Programming

1. Press **MENU BUTTON**
2. Enter **INSTALLER CODE** (Default: 1111)
3. Navigate to **"PROGRAMMING"** → ENTER
4. Navigate to **"COMMUNICATION"** → ENTER

---

#### Monitoring Station Setup

Navigate to **"MONITORING STATION (MS)"** → ENTER  
Navigate to **"MONITORING STATION 1 (MS 1)"** → ENTER

Configure the following:
- **TYPE** = VOICE
- **CHANNEL** = PSTN/GSM
- **ACCOUNT** = 6 digit code provided by office (e.g., 001052)
- **PHONE** = 555 555 5
- **MS RETRIES** = 3

---

#### Timer Configuration

Navigate to **"TIMERS"**:
- **CANCEL DELAY** = 0
- **ABORT ALARM** = 0

---

#### Periodic Test Setup

Navigate to **"PERIODIC TEST"**:
- **TIME** = 2200 (for 10:00 PM test)
- **RECURRENCE** = EVERY 1 DAY

---

#### Report Split Configuration

Navigate to **"REPORT SPLIT"**:
- **ARM/DISARM** = "NON" for DOMESTIC / "CALL MS1 ONLY" for COMMERCIAL
- **MS URGENT** = "CALL MS1 ONLY"
- **MS NON URGENT** = "CALL MS1 ONLY"

---

#### Cloud Settings

Back to main COMMUNICATION menu  
Navigate to **"CLOUD"**:
- **MS CALL ALL** = ENABLED
- **FM CALL ALL** = ENABLED

---

#### Exit Programming

1. Press MENU
2. Press MENU
3. Press MENU, 0, ENTER to exit

---