Chapter 7: Other Panels

Orisec Configuration
Orisec panels support both Tip/Ring and Com Port connections 
 
 Orisec Tip/Ring Configuration 
 
 Enter Installer Code 
 Select Programming Menu → Tick/Enter 
 Go to ARC Set up 
 Phone Number : 555 5555 
 Account Number : As supplied by control room/software 
 Protocol : Contact ID 
 Dial Seq : 1 
 Any issues with not sending - RESTART PANEL 
 
 
 Orisec Com Port Configuration 
 
 Enter Installer Code 
 Select Programming Menu → Tick/Enter 
 Com Port Setup → Tick/Enter 
 Select Com Port number 2 
 Set mode to FINMON (Required for app) 
 Hold Tick to go back 
 Go to ARC Set up 
 Phone Number : F555 5555 (Note the 'F' prefix) 
 Account Number : As supplied by control room/software 
 Protocol : Contact ID 
 Dial Seq : 6 
 Any issues with not sending - RESTART PANEL 
 
 
 App Configuration 
 Requirements: 
 
 App version must be v4.37 
 Serial Port must be set to Orisec/IDS 
 MUST be set to FINMON under Comm Port Setup 
 
 
 Critical Notes 
 IF YOU AREN'T GETTING SIGNALS OUT: 
 
 REBOOT THE PANEL 
 If serial port connected with panel powered up, it won't be detected 
 Always power cycle after connecting serial

Risco Configuration
Complete programming guide for Risco panels 
 
 Accessing Programming 
 
 Press MENU BUTTON 
 Enter INSTALLER CODE (Default: 1111) 
 Navigate to "PROGRAMMING" → ENTER 
 Navigate to "COMMUNICATION" → ENTER 
 
 
 Monitoring Station Setup 
 Navigate to "MONITORING STATION (MS)" → ENTER 
Navigate to "MONITORING STATION 1 (MS 1)" → ENTER 
 Configure the following: 
 
 TYPE = VOICE 
 CHANNEL = PSTN/GSM 
 ACCOUNT = 6 digit code provided by office (e.g., 001052) 
 PHONE = 555 555 5 
 MS RETRIES = 3 
 
 
 Timer Configuration 
 Navigate to "TIMERS" : 
 
 CANCEL DELAY = 0 
 ABORT ALARM = 0 
 
 
 Periodic Test Setup 
 Navigate to "PERIODIC TEST" : 
 
 TIME = 2200 (for 10:00 PM test) 
 RECURRENCE = EVERY 1 DAY 
 
 
 Report Split Configuration 
 Navigate to "REPORT SPLIT" : 
 
 ARM/DISARM = "NON" for DOMESTIC / "CALL MS1 ONLY" for COMMERCIAL 
 MS URGENT = "CALL MS1 ONLY" 
 MS NON URGENT = "CALL MS1 ONLY" 
 
 
 Cloud Settings 
 Back to main COMMUNICATION menu 
Navigate to "CLOUD" : 
 
 MS CALL ALL = ENABLED 
 FM CALL ALL = ENABLED 
 
 
 Exit Programming 
 
 Press MENU 
 Press MENU 
 Press MENU, 0, ENTER to exit