Trigger Inputs Z1-4 on Transmitter

This page covers the configuration of direct trigger inputs on the Finmon transmitter.

Default Configuration

Factory Default Account Code: 9998

When a transmitter is connected to a panel via serial/dialler:

• The panel will automatically update the radio with its account code on first signal
• If the account code is changed on the panel, it will update the radio again

Direct Connection to Z1-4

When connecting directly to trigger inputs (not through a panel):

1. Account Code Programming

   • Must be set by dialling into the radio over the internet
   • Use Finmon website: www.finmon.co.za
   • REFER TO YOUR FINMON CONSULTANT OR CONTROL ROOM

2. Voltage Requirements

   • The radio requires a positive 12v trip on any of the triggers.
   • Ensure clean, stable 12v signal

Default Trigger Assignments

Reprogramming Triggers

The trigger inputs can be reprogrammed for any Contact ID reporting code:

• Examples: supervisor on site, pump failure, temperature alarm
• Access required via Finmon website
• Contact Finmon support for custom programming

Wiring Notes

• Use appropriate gauge wire for 12v signals
• Keep wiring runs as short as practical
• Avoid running trigger wires parallel to AC power
• Use shielded cable in high-interference environments