Trigger Inputs Z1-4 on Transmitter

This page covers the configuration of direct trigger inputs on the Finmon transmitter. 
 
 Default Configuration 
 Factory Default Account Code: 9998 
 When a transmitter is connected to a panel via serial/dialler: 
 
 The panel will automatically update the radio with its account code on first signal 
 If the account code is changed on the panel, it will update the radio again 
 
 
 Direct Connection to Z1-4 
 When connecting directly to trigger inputs (not through a panel): 
 
 
 Account Code Programming 
 
 Must be set by dialling into the radio over the internet 
 Use Finmon website: www.finmon.co.za 
 REFER TO YOUR FINMON CONSULTANT OR CONTROL ROOM 
 
 
 
 Voltage Requirements 
 
 The radio requires a positive 12v trip on any of the triggers. 
 Ensure clean, stable 12v signal 
 
 
 
 
 Default Trigger Assignments 
 
 
 
 Input 
 Default Function 
 
 
 
 
 Z1 
 Panic 
 
 
 Z2 
 Burglary 
 
 
 Z3 
 Open by user / Close by User 
 
 
 Z4 
 AC Failure 
 
 
 
 
 Reprogramming Triggers 
 The trigger inputs can be reprogrammed for any Contact ID reporting code: 
 
 Examples: supervisor on site, pump failure, temperature alarm 
 Access required via Finmon website 
 Contact Finmon support for custom programming 
 
 
 Wiring Notes 
 
 Use appropriate gauge wire for 12v signals 
 Keep wiring runs as short as practical 
 Avoid running trigger wires parallel to AC power 
 Use shielded cable in high-interference environments