New Page

miPanic Quick Reference Guide

The miPanic is a versatile security system featuring 4 supervised zones and support for up to 64 user codes or remotes via a built-in receiver.

---

1. System Overview

• Zones: 4 Supervised zones (Requires $3.3k\Omega$ End-of-Line resistors).
• Capacity: 64 User codes and/or remotes.
• PGM Output (ARM LED Mode):
  • Solid: System Armed.
  • Off: System Disarmed.
  • Flashing: Alarm has been triggered.
  • Flickering: Force armed (armed while a zone was open).
  • Zone Logic: If armed with an open zone, that zone is ignored until it closes, then it becomes active.

---

2. Programming: No Keypad (Jumper Method)

To program using the jumpers on the board:

1. Set the jumpers to the desired configuration (see table below).
2. Hold the Reset button down.
3. Connect power to the board.
4. Release the Reset button once LED 1 flashes briefly.

Configuration Modes

Setup Type	Zone Logic
Panic Setup	All zones function as Panic zones.
Mini Alarm	Zones 1-3: Burglary; Zone 4: Panic.
Mini Alarm (Delay)	Zone 1: Entry/Exit Delay; Zones 2-3: Burglary; Zone 4: Keyswitch.

Remote Management (Jumper Method)

• Add Remotes: Set jumpers to "Add" position $\rightarrow$ Hold Reset until LED 1 flashes $\rightarrow$ Press any remote button (Siren will toot).
• Delete All Remotes: Set jumpers to "Delete All" position $\rightarrow$ Hold Reset until LED 1 flashes.
• Delete Individual Remote: Set jumpers to "Delete Individual" position $\rightarrow$ Hold Reset until LED 1 flashes $\rightarrow$ Press a button on the specific remote to remove it.

---

3. Programming: With Keypad

Installer Mode

Access by entering: [Installer Code] (Default 9999) + *

Location	Description	Details
0	Default Options	0=All, 1=Master Code (1234), 2=Users, 3=Download Code, 4=WiFi, 5=Wireless Sensors.
1	Panel Setup	1=Panic, 2=Mini Alarm, 3=Mini Alarm with Delay.
2	Account Code	Enter 4-digit code for reporting.
3	Installer Code	Enter new 4-digit installer code.
4	Enroll Wireless	(Firmware E3.04 and up).

User Code Programming

Access by entering: Alt + * + [Master Code] (Default 1234) + *

Loc	Action	Instruction
1	Add User	Enter 4-digit code + *. Press remote button to link, or # to skip.
2	Change User	Enter existing code + *. Enter new code or press remote button.
3	Delete User	Enter 4-digit code + * to remove both code and remote.
4	Delete by ID	Enter User Number (e.g., 1 for Master) + *.
5	Add Remote Only	Press remote button to enroll. Repeat for more, press # to exit.

---

4. User Operations

Bypassing Zones

1. Press Alt + 9.
2. Press the Zone Number followed by * to toggle bypass.
3. Press # to exit.
   • Note: Panic and Keyswitch zones cannot be bypassed.

Trouble Conditions

If the Power LED is flashing Red, press Alt + 7. The Zone LEDs will indicate the specific issue:

LED	Description	LED	Description
1	Siren Tamper	5	Comms Fail
2	Aux 12V Fuse	6	Low Battery
3	Box Tamper	7	Network Problem
4	AC Fail

---